Pearl Bangles - Goa
The required bangle base is selected, and the number of pearl beads needed is chosen. The thread is cut as per the length preferred. A little longer than necessary is cut. A knot is made using both ends of the thread. Further, the desired coloured beads are inserted in the thread one by one. This thread is then inserted into one of the holes in the bangle base/mold, and the thread is brought out through the second next hole. Again the beads are inserted into the thread and are inserted in the hole, and tightened. The process is repeated to complete the whole bangle. Once the beads are wholly threaded to the bangle base, the thread is taken inwards of the bangle and tightly knotted together. The excess thread is cut off. Then by using the incense stick, the ends of the knots are heated by its foam. Upon that is the glue applied to make them stick together and hard. As the final finishing, transparent nail polish is applied on the bangle base and other decorative accessories (that are golden in colour) used for the bangle. As this gets dried up soon, thus the bangles get ready to be sold or worn instantly!
Flow Chart:
