Fig. 58 Dimensional measurements, Bending the rocker bottom, joining
different parts using gas welding.



Fig. 59 Slight adjustments being done by hammering, unfinished frame
of the rocking chair, Smoothening of surfaces.



Fig. 60 Preparation of mould for casting the seat, chopping of fibers into
smaller pieces, chopped fibers are then grounded into the grinder.



Fig. 61 Applying castor oil to the foil for easy removal of the composite
material, adding all the ingredients and stirring them until they become
a unified paste, mixture is poured onto the mould which is then pressed
using a hydraulic press.



Fig. 62 Letting the mould cool down overnight, removing the final seat
from the mould, Final rocking chair.